Directed Electronics 3808A Installatiehandleiding - Pagina 17

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Directed Electronics 3808A. Directed Electronics 3808A 18 pagina's. Auto-mate

Pagina afdrukken

Directed Electronics 3808A Installatiehandleiding

Disarming

1. Press the

button.

2. Doors unlock, Lights flash twice, dome light turns on, starter kill becomes inactive, and the status LED turns

off.

3. Passive arming begins (see previously described Arming Passive).

A U X

Car Finder

1. Press and release the AUX button prior to pressing the

2. The horn/siren emits one sound and the lights flash 10 times

3. Press the

buttons to stop the feature.

Nuisance Prevention Circuitry (NPC)

A U X

NPC monitors all alarm zones and, if any are triggered three times within an hour, bypasses them until

A U X

corrected. If a point of entry (trunk, hood, or door) is left open following a forced entry, it is bypassed. It be-

comes active again only after being closed. Bypassed sensors automatically reset after one hour and after

the vehicle is driven. Disarming then re-arming the alarm does not reset bypassed sensors.

Long Term Event History

The system stores the last two full triggers in memory. These are not erasable. Each time the unit sees a full

trigger, the older of the two triggers in memory is replaced by the new trigger. To access long term event

history:

1. With the ignition Off, press and hold the Valet button

2. Turn the ignition On.

3. Release the Valet button.

4. Within 5 seconds, press and release the Valet button. The status LED flashes in groups indicating the

last two zones that triggered the unit for 1 minute or until the ignition is turned off. Refer to table of

zones.

Note: The Warn Away triggers are not stored to memory and are not reported.

Table of Zones

When arming the system with an active zone or when the system has been triggered, the LED will flash to

indicate the zone that is active or has been triggered. A zone is represented by the number of LED flashes

used by the system to identify a particular type of input.

LED Flashes

Input Trigger

Trunk Input

Shock Sensor

Door Trigger

Not Used

Ignition Trigger

Hood Input

Note: The Pre-trigger does not report on the LED

Rapid Resume Logic

This system will store its current state to non-volatile memory. If power is lost and then reconnected the sys-

tem will recall the stored state from memory. This means if the unit is in valet mode and the battery is discon-

nected for any reason, such as servicing the vehicle, when the battery is reconnected the system will still be

in valet mode. This applies to all states of the system including arm, disarm and valet mode.

AUX

button