Directed Electronics Xtreme XA-3002 Gebruikershandleiding - Pagina 11

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Directed Electronics Xtreme XA-3002. Directed Electronics Xtreme XA-3002 20 pagina's. Directed electronics amplifier owner's manual

Pagina afdrukken

REAR PANEL CONNECTIONS—XA-3002/XA-6002

N N O O T T E E : : The numbers listed below are referenced on the Speaker Wiring Diagram.

10. S S p p e e a a k k e e r r C C o o n n n n e e c c t t i i o o n n s s - Note that the

two speakers & four speakers have

been connected to the four terminal

following the (+) and (-) graphic.

Your speaker terminal may be

marked (+) and (-) or there may

be red dot by one terminal which

means the same as (+).

Connecting the speakers in this

manner assures that the two

speaker cones will move in and out

together according to the original

recording. If one of the two

speakers is reversed, stereo

imaging and bass response will be

degraded.

Refer to the specifications for the

wire size to be used with your

amplifier.

11. A A T T C C F F u u s s e e s s - protects the amplifier

from over current situations. See

specification for fuse size for your

amplifier. N N o o t t e e : : The XA-3002 has

only one fuse.

12. ( ( + + ) ) 1 1 2 2 V V o o l l t t P P o o w w e e r r - Connect this

terminal through a FUSE or CIRCUIT

BREAKER to the positive terminal of

the vehicle battery or the positive

terminal of an isolated audio

system battery. Refer to the specifi-

cations for the wire size to be used

with your amplifier.

W W A A R R N N I I N N G G : : Always protect this power wire by installing a fuse

or circuit breaker of the appropriate size within

12 inches of the battery terminal connection.

R R e e m m o o t t e e T T u u r r n n O O n n - This terminal

turns on the amplifier when (+) 12

volt is applied to it. Connect it to

the remote turn on lead of the head

unit or signal source. If a (+) 12

volt remote turn lead is not avail-

able, a Remote Power Adapter

(P/N #55000) can be used to

supply a remote turn on signal. DO

NOT connect this terminal to

constant (+) 12 volt.

G G r r o o u u n n d d - - Connect this terminal

directly to the sheet metal chassis

of the vehicle using the shortest

wire necessary to make this

connection. Always use wire of the

same gauge or larger than the (+)

12 volt power wire. The chassis

connection point should be scraped

free of paint and dirt. Use only

quality crimped and/or soldered

connectors at both ends of this

wire. DO NOT connect this terminal

directly to the vehicle battery

ground terminal or any other

factory ground points.