Directed Video WHS104 Handmatig

Blader online of download pdf Handmatig voor {categorie_naam} Directed Video WHS104. Directed Video WHS104 1 pagina's. Automotive wireless headphone system

P P a a r r t t s s S S u u p p p p l l i i e e d d
One IR Transmitter.
One IR Transmitter Harness.
Two IR Headphones
.
I I m m p p o o r r t t a a n n t t N N o o t t e e s s
For best results, the IR transmitter must be installed as shown in figure 1
with the LEDs pointing towards the rear of the vehicle.
Audio input can be connected to either a low-level fixed audio output or a
variable level audio output (such as a speaker or headphone output). If it is
connected to a low-level output, only the volume control on the headphones
needs to be adjusted to control volume level. If connected to a variable level
outputs, then the volume adjustment needs to be accomplished at both the
sources and at the headphones.
W W i i r r e e H H a a r r n n e e s s s s ( ( w w i i t t h h R R C C A A c c o o n n n n e e c c t t o o r r s s ) )
1. Using the dual RCA (M/M) cables (not supplied—length to be determined
by installation requirements), connect each to the Red and White RCA jacks.
Connect the other end to each of the low level signal sources (left and right
channels).
2. Connect wire 3 of the harnness (Black wire, negative) to the ground of
the vehicle.
3. Connect wire 4 of the harness (Red wire, +12 volt) to the ignition source.
This is an ignition wire that provides +12V when the ignition key is turned
on.
I I R R T T r r a a n n s s m m i i t t t t e e r r
1. Plug wire harness into transmitter.
2. Remove the 2 plastic caps on the transmitter to exposed the mounting
screw holes (figure 3).
3. Fasten transmitter to headliner using two short metal screws. U U s s e e c c a a u u - -
t t i i o o n n , , d d o o n n o o t t d d r r i i l l l l t t h h r r o o u u g g h h t t h h e e r r o o o o f f o o f f t t h h e e v v e e h h i i c c l l e e . . L L o o c c a a t t e e a a r r o o o o f f m m e e t t a a l l b b e e a a m m
o o r r g g l l u u e e a a p p i i e e c c e e o o f f w w o o o o d d t t o o t t h h e e m m e e t t a a l l r r o o o o f f . .
4. Reinstall the plastic caps.
W W i i r r e e l l e e s s s s H H e e a a d d p p h h o o n n e e s s
Follow the instuctions with the owner's manual for the headphones for prop-
er operation.
F F i i g g u u r r e e 1 1 — — T T r r a a n n s s m m i i t t t t e e r r M M o o u u n n t t i i n n g g D D i i a a g g r r a a m m
©
2005 Directed Electronics—all rights reserved
W W H H S S 1 1 0 0 4 4 A A U U T T O O M M O O T T I I V V E E W W I I R R E E L L E E S S S S
H H E E A A D D P P H H O O N N E E S S Y Y S S T T E E M M
F F i i g g u u r r e e 1 1 — — T T r r a a n n s s m m i i t t t t e e r r M M o o u u n n t t i i n n g g D D i i a a g g r r a a m m , , c c o o n n t t i i n n u u e e d d
F F i i g g u u r r e e 2 2 — — W W i i r r i i n n g g H H a a r r n n e e s s s s e e s s
F F i i g g u u r r e e 3 3 — — I I R R T T r r a a n n s s m m i i t t t t e e r r
N88404 10-05