Clarke 6462552 Handleiding voor bediening en onderhoud - Pagina 10
Blader online of download pdf Handleiding voor bediening en onderhoud voor {categorie_naam} Clarke 6462552. Clarke 6462552 17 pagina's.
CUTTING TIPS
WARNING: IF THE CUTTING OPERATION IS DUSTY, WE RECOMMEND THAT
YOU WEAR A DUST
GENERAL CUTTING
• Allow the tool to reach full speed before touching the work material.
• Guide the saw blade into the workpiece keeping the shoe pressed
firmly against the workpiece while cutting to prevent tool kickback.
• Do not press too hard, if the saw slows down as it is cutting, apply less
pressure.
• Allow the saw to come to a complete stop before setting it down.
• To prevent accidents, turn off the saw and disconnect its power
supply after use. Clean, then store the saw indoors out of the reach
of children.
PLUNGE CUTTING
Plunge cut into plywood and thin board panels. Do not attempt to plunge cut
into thick, hard wood or metal panels.
1. Clearly mark the line of cut.
2. From a convenient starting point within the cutting area, place the tip of
the blade over that point with the saw parallel to the line of cut.
3. Place the edge of the pivot shoe
on the work piece with the blade
NOT touching the work material.
• Never start a plunge cut with
the blade tip touching the work
piece. this will cause an
immediate kick back that can
damage the work piece, the
blade or cause injury.
4. Squeeze the trigger. When the
saw reaches full speed, slowly rotate the tool on the pivot shoe until the
blade has penetrated through the work material.
• Hold the tool firmly.
5. Press the pivot shoe firmly against the work material and continue to make
the cut.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MASK.
10