Clarke contractor CON100 Gebruiks- en onderhoudsinstructies - Pagina 4
Blader online of download pdf Gebruiks- en onderhoudsinstructies voor {categorie_naam} Clarke contractor CON100. Clarke contractor CON100 17 pagina's. Contractor reciprocating saw
Pagina afdrukken
GENERAL SAFETY PRECAUTIONS
16.
ALWAYS remove plug from electrical outlet when
adjusting, changing parts, or working on the machine.
17.
NEVER operate machine while under the influence of
drugs, alcohol or medication.
18.
NEVER leave machine running unattended. Turn power off.
Do not leave the machine until it comes to a complete
stop.
19.
NEVER force the machine. It will do a better and safer job at
the rate for which it was designed.
20.
NEVER use power tools in damp or wet locations or expose
them to rain. Keep your work area well illuminated. Do not
use in explosive atmosphere (around paint fumes,
flammable liquids etc.). Avoid dangerous environments.
ADDITIONAL WARNINGS FOR RECIPROCATING
SAWS
1.
ALWAYS wear ear protectors/defenders as the noise level of this machine can
exceed 85dB (A).
2.
ALWAYS use the appropriate blade for the material being cut.
3.
ALWAYS keep the mains cable well away from the machine and ensure an
adequate electrical supply is close at hand so that the operation is not restricted by
the length of the cable.
4.
ALWAYS switch the machine OFF immediately the task is completed.
5.
ALWAYS ensure the blade is fully tightened before use.
6.
ALWAYS allow sufficient clearance beneath the work to ensure the blade does not
come into contact with the floor, table etc.
7.
ALWAYS check for hidden electrical wires or water pipes etc.
8.
NEVER allow the ventilation slots in the machine to become blocked.
9.
DO NOT cut material above the specified thickness.
10.
DO NOT cut through walls or cavities before checking for hidden electrical wires or
water pipes etc.
11.
DO NOT touch the blade immediately after use, allow time for it to cool.
12.
DO NOT cut work less than at least twice the pitch of the saw blade. i.e. at least two
teeth must be in contact with the work at all times.
13.
DO NOT use the machine if the electric cable, plug or motor is in poor condition.
14.
When cutting wood, ensure all nails have been removed beforehand. Nails will
damage the wood saw blade.
15.
When cutting metals, always use a cooling agent i.e. cutting/soluble oil.
Additionally, please keep these instructions in a safe place for future reference.
4