Clarke Devil 370P Gebruiks- en onderhoudsinstructies - Pagina 7

Blader online of download pdf Gebruiks- en onderhoudsinstructies voor {categorie_naam} Clarke Devil 370P. Clarke Devil 370P 13 pagina's. Devil quartz infra-red halogen heaters

Clarke Devil 370P Gebruiks- en onderhoudsinstructies

OPERATION

1. Position the heater where required, and lock the castors to prevent the
heater from rolling.
2. Slacken the locking knobs and rotate the heater body to the required
angle. Tighten the securing knobs on each side to lock into place (SP
models only).
3. Connect the mains cable to a suitable power supply.
4. Use the on/off switches to turn on either one, or both heating elements.
When using the SP model heaters, the angle of tilt MUST NOT exceed 45
degrees downwards, as this could lead to the heater overheating. NEVER
position the heater pointing vertically downwards.
CLEANING & MAINTENANCE
If the heater has been used, ALWAYS allow it to cool down for at least 15
minutes and disconnect from the mains supply before performing any
maintenance tasks.
PERIODICALLY
• If there is any serious build up of dirt, wipe thoroughly with a damp cloth.
Take care that no moisture enters the heater. Take care NOT to touch the
tubes with your fingers.
• Inspect the mains cable for damage. Undue heat will cause the cable to
stiffen and crack. If this is found, have the cable replaced. Check cable
routing and ensure it is well away from the heat source.
• Ensure heating lamps are clear of dust (use compressed air to clean if
possible. (ALWAYS wear a dust mask if performing this operation)
• Refer to your CLARKE dealer if internal maintenance is required.
• When storing the heater, allow it to cool down, then place it in its packing
box for storage in a dry, ventilated place.
FITTING/ REPLACING LAMPS
Before attempting to fit/replace halogen lamps, ensure the heater is
switched off and isolated from the main electrical supply by removing the
plug from the socket.
NEVER handle the heater lamps with bare hands. ALWAYS handle using either
a soft clean glove or a piece of soft clean cloth wrapped around the lamp.
IMPORTANT!
7