DirecTV Digital Satellite Recorder Handleiding voor probleemoplossing - Pagina 6

Blader online of download pdf Handleiding voor probleemoplossing voor {categorie_naam} DirecTV Digital Satellite Recorder. DirecTV Digital Satellite Recorder 19 pagina's.

Pagina afdrukken

Using Code Search to find a code for your remote

If you have been trying to program your DIRECTV ® Digital Satellite Recorder remote to control a

TV or A/V system, and have not been able to find a code that works with your device's

manufacturer or model, you may be able to program the remote with a code search. Performing a

code search can take up to 20 minutes.

1. Prepare the remote control. Point the remote away from your DIRECTV Recorder and cover the

front end with your hand. Determine which two buttons to press:

To Control:

TV Power, Volume and Mute

TV Input (on remotes where this button is available)

A/V Receiver Power, Volume and Mute

A/V Receiver volume and mute only

Press and hold the buttons simultaneously until the red light at the end of the remote control

comes on, remains steady, then stays on when you release the buttons.

2. Enter the search code. Refer to the table below and use the number keys on your remote

control to enter the appropriate code.

To Test:

TV Power, Volume and Mute

TV Input (on remotes where this button is available)

A/V Receiver Power, Volume and Mute

A/V Receiver volume and mute only

After you press the fourth digit of the code, the red light on the end of the remote will flash

twice, then remain on.

Test the remote control. Point the remote control at the TV or A/V receiver. Press CHAN UP. Did

the TV or A/V receiver respond? If not, continue to press CHAN UP to test codes (there are

hundreds). Wait two or three seconds each time after pressing CHAN UP to give your device time.

When the TV or A/V receiver responds, press ENTER to select the current code. The red light at

the end of the remote will flash three times to indicate that the remote can now control your device.

When the red light on the end of the remote control turns off, you have reached the end of the

available codes. Unfortunately, due to the great variety of TVs and A/V receivers, some makes

and models are not compatible with your recorder's remote. If you reach the end of the available

codes without finding a code that works, you'll need to continue to use your TV or A/V receiver's

remote to control your TV or A/V receiver.

Page 6

Press and Hold:

TV PWR and

DIRECTV buttons

TV INPUT and

DIRECTV button

TV PWR and

DIRECTV buttons

MUTE and

DIRECTV buttons

Enter:

0999

1999