CLAS OM 9203 Handmatig - Pagina 12

Blader online of download pdf Handmatig voor {categorie_naam} CLAS OM 9203. CLAS OM 9203 20 pagina's. Coffret extracteur injecteurs fiat, coffret extracteur injecteurs fiat

Pagina afdrukken

OM 9203

INJECTOR EXTRACTOR SET FIAT

INTRODUCTION

It is compulsory to read this instruction manual before starting any kind of action.

The proper operation and full compliance of this product's performance is guaranteed only if all

the instructions provided in this manual are closely adhered to.

We guarantee that this product complies with the technical specifications described in this manual.

The manufacturer shall not be held responsible for any improper uses other than those described

herein.

Use protective work gloves, protective footwear, hard hat and safety goggles.

Misuse:

• This product should only be used as described in this documentation; any other use is considered

improper.

• The manufacturer accepts no responsibility for any damage caused by the incorrect or

unreasonable use of the equipment.

• Moreover, misuse shall also void the warranty.

Take care of your tools:

• Be sure to store your tools in a clean state.

• Place the tools inside their original package.

CAUTION - is used to indicate correct operating or maintenance procedures to prevent damages

to the equipment or the surrounding environment:

• Always check the integrity of the cylinder;

• Keep the cylinder away from flames, heat and sparks;

• Do not use the cylinder outside the temperature range indicated in table A;

• In case of topping up or replacement of grease, use a lubricant compatible with the gaskets

assembled on the cylinder, see use temperatures and viscosity table A;

WARNING - indicates a potential danger that requires correct procedures or practices to avoid

personal injury:

•Always wear personal protective devices when operating, handling and maintaining the equipment

(protective gloves against mechanical risks and goggles with lateral protection);

• Do not use pneumatic or electric screwers to screw the pusher (CH. 19) that is on the handle or

use extensions to increase the torque;

• Select steel or wood blocks that are capable of supporting the maximum load of the cylinder

and place them under or on it;

• Do not use the cylinder as thickness element or wedge;

• Cylinders should be placed on a flat surface before their use. The configuration of the components

under strain should be stable;

• Distribute the load evenly across the entire saddle surface (piston) in order to avoid misalignments

or situations which could lead to slipping of the parts under strain;

•Immediately replace worn or damaged parts by genuine Clas parts.