Nikon DS-5MC Gebruiksaanwijzing - Pagina 4

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Nikon DS-5MC. Nikon DS-5MC 49 pagina's. Ds camera control unit, ds camera head, ds cooled camera head
Ook voor Nikon DS-5MC: Gebruiksaanwijzing (47 pagina's), Snelle referentie (15 pagina's)

Nikon DS-5MC Gebruiksaanwijzing
Warning
1. Intended application of this product
Use this product only for photomicrography. Do not use this product for other purpose.
2. Do not repair nor disassemble.
The AC adapter for the DS-U2 contains a high-voltage power supply. Never attempt to disassemble or
repair the equipment by yourself; doing so may result in electric shock or equipment failure. Never attempt
to disassemble any part of the equipment unless instructed to do so in this manual. If you notice any
problems with the equipment, turn off the power and contact your nearest Nikon representative.
3. AC adapter
Use the specified AC adapter. Using a wrong adapter may result in fire or electric shock.
Refer to "3. DS AC adapter" in Chapter 9, Specifications for details.
4. Power cord
To prevent electric shock, be sure to turn off the power switch of the DS-U2 before attaching or detaching
the power cord.
For the DS-U2, use only the specified AC adapter and power cord.
The specifications of the power cord are shown below. Using a wrong power cord may result in fire or
other hazardous condition.
This product is classified as Class I protection against electric shock. Therefore, make sure that the power
supply is connected to an appropriate ground terminal (protective earth terminal). If you lose or damage
the power cord, contact your nearest Nikon representative.
For regions where the power supply is 100 to 120 VAC
Attachable and detachable power cord set approved by the UL
3 conductor grounding Type SVT. No.18 AWG, 3m long maximum, rated at 125 VAC minimum
For regions where the power supply is 220 to 240 VAC
Approved according to EU/EN standards,
3 conductor grounding Type H05VV-F, 3m long maximum, rated at 250 VAC minimum
5. Handling
To prevent malfunctions or abnormal heating due to short circuits, do not wet this product and
others used with this product nor allow foreign matters to be intruded. If these products get wet, or
if foreign matter such as a piece of paper gets inside, immediately turn off the power switch of the
DS-U2 and unplug the power cord from the wall outlet. Then, contact your nearest Nikon
representative.
To prevent fire or burn injury due to the breakage of a cable, do not excessively bend nor twist the
cables.
To prevent fire due to heating, do not place a cloth or paper on the DS-U2 nor block the vent of the
DS-U2.
- ii -