Nikon Eclipse E600 Gebruiksaanwijzing - Pagina 3

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Nikon Eclipse E600. Nikon Eclipse E600 37 pagina's. Teaching head/multi teaching head
Ook voor Nikon Eclipse E600: Gebruiksaanwijzing (38 pagina's), Gebruiksaanwijzing (37 pagina's), Gebruiksaanwijzing (21 pagina's)

Nikon Eclipse E600 Gebruiksaanwijzing
Anne
1.
Intended product use
This microscope should only be used for microscopic observation. Do not use it for any other purpose.
Do not disassemble
Disassembling may cause malfunction and/or electrical shock.
Do not disassemble any paris other
than those mentioned in this manual.
If you notice any malfunction, notify your nearest Nikon
representative.
Input voltage
Make sure that the input voltage indicated on the
back panel of the microscope is the same as your
regional voltage.
If not the same, do not use the
microscope; instead, notify your nearest Nikon
representative immediately.
If the microscope is
used with the wrong input voltage, a short circuit
or fire may result, causing the damage of the
microscope.
Power cord
To prevent electrical shock, always turn off the
power switch (flip it to the " *" side) before
connecting or disconnecting the power cord. Use
only the following power supply cord set. Using
the wrong power cord could result in damage or
fire.
* For 100-120V area
UL Listed, detachable cord set, 3 conductor
grounding type SVT, No. 18 AWG
rated at
125V,7A minimum.
In case of using the extension cord, use only
the power supply cord with the PE (protective
earth) wire.
+ For 220- 240V area
3 pole power supply cord set, which must be
approved according to EU/EN standards.
Class I equipment should be connected to PE
(protective earth) terminal.
In case of using the extension cord, use only
the power supply cord with the PE (protective
earth) wire.
Heat from the light source
The lamp and the lamphouse become extremely
hot. To avoid burns, do not touch the lamphouse
while the lamp is lit or for thirty minutes after it
has been turned off.
Furthermore, in order to avoid the risk of fire, do
not place fabric, paper or highly flammable
materials such as gasoline, petroleum benzine,
paint thinner or alcohol near the lamphouse while
it is lit or for about thirty minutes after it has been
turned off.
The back of the microscope also becomes hot
during use.
Although this is not a malfunction,
be careful not to touch the back of the microscope
when it is hot.
Nikon
MODEL
ECLIPSE
E600
120V~
24A
50/60HZ
MADE
IN JAPAN