Nikon autofocus speedlight SB-900 Handmatig - Pagina 7
Blader online of download pdf Handmatig voor {categorie_naam} Nikon autofocus speedlight SB-900. Nikon autofocus speedlight SB-900 8 pagina's. Speedlight
Ook voor Nikon autofocus speedlight SB-900: Gegevensblad (2 pagina's)
Pagina afdrukken
NIKON'S EXCLUSIVE BUILT-IN
I-TTL FLASH SYSTEM WITH
WIRELESS CAPABILITIES WITH
THE D700, D300, D300S, D7000,
AND D90 DIGITAL SLRS
1. The Wireless Flash Commander mode option can be selected
within the Custom Settings menu under the built-in flash
option of the D700, D300, D300S, D7000, and D90 cameras.
D700 – Custom Setting: e3
D300 – Custom Setting: e3
D300S – Custom Setting: e3
D7000 – Custom Setting: e3
D90 – Custom Setting: e2
2. When you enter the Commander mode, the built-in flash,
Group A and Group B are all activated and set to TTL
with zero exposure compensation. In this scenario, the
built-in flash will send a pre-flash signal for the remote
units to fire, as well as trigger the remote Speedlights and
factor into the lighting scheme and final exposure.
3. Flash compensation can be adjusted for Groups A and B, as
well as the built-in flash. Press the camera's Multi-selector
right or left to move into the Mode or Compensation windows
for the built-in flash and both Groups. Use the up and down
arrows with the Multi-selector to set the desired values.
4. The built-in flash, as well as the A and B Groups, can be set to
fire and be factored into the exposure, or turned off individually,
based on your lighting requirements. Toggle the Multi-selector
to the right to enter the Mode window for the item you would
like to turn off. Toggle the Multi-selector down until you see
the dashed lines. This means that the built-in flash or selected
Speedlight will NOT fire.*
*Note: Although you may turn off the built-in flash from being
calculated into the exposure, the built-in flash unit must stay in
the up position, as it will still send the pre-flash signal to control
the remote units.
Once you have set the Commander mode as desired,
be sure that the channel you have selected matches
the channel set on the remote units. Also, be sure to press
the "OK" button to confirm and set the Commander mode.
Note: Wireless Flash Commander Mode works in only P, S, A or M
and is not available in Scene Modes. The D70/D70s Commander
mode operation communicates only in Channel 3/Group A.