Dirty Hand Tools 101571 Bedieningshandleiding - Pagina 11

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Dirty Hand Tools 101571. Dirty Hand Tools 101571 20 pagina's. 15” front tine tiller

Pagina afdrukken

HEX NUT

CABLE

LENGTH

ADJUSTER

Figure 6

Figure 7

Driver Safety Control Lever Assembly

Mounting the Driver Safety Control Lever

1. Position the Driver Safety Control Lever onto the right handlebar.

2. Push a threaded hex bolt through the top of the handlebar into the

safety control lever and tighten securely (see Figure 6).

3. Adjust the tension on the driver safety control lever by loosening the

hex nut and rotating the threaded cable length adjuster. Then re-

tighten the hex nut against the lever to lock the cable length.

e correct tension will engage the tines about half way between being

completely released and held all the way up against the handlebar grip.

NOTE:

e driver safety control lever must be adjusted prior to use and

checked periodically for the correct tension. Adjust the tension on the

cable so the belt is ﬁrm when the lever is pulled up towards the handlebar

grip. Use caution as to not over tension the cable as too much tension will

cause excessive wear on the belt.

rottle Control Lever Assembly

Mounting the

rottle Control Lever

1. Position the

rottle Control Lever onto the left handlebar.

2. Push a threaded hex bolt through the base of the lever and secure with

a nylock hex nut (see Figure 7).