Blacoh Sentry Installatie- en bedieningshandleiding - Pagina 9

Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} Blacoh Sentry. Blacoh Sentry 12 pagina's. Pulsation & surge control dampener (chargeable model)

Pagina afdrukken
R
B
I
EAD
EFORE
NSTALLATION
Step 1 — Installation Position
Install the dampener in-line, as close as possible to and before the device causing the water hammer pressure
spike (see FIGURE 2). For example, if a quick closing valve is causing water hammer, install the dampener on a
tee or elbow as close as possible upstream of the valve. Dampener installation should be no more than ten pipe
diameters from the valve. It is advisable to install an isolation valve between the dampener inlet and the
mounting tee so maintenance and pressure checks can be done while the system is operating.
Step 2 — Charging and Start-Up (see Pre-Charge Notes)
Chargeable models do not require an air line connection. Dampener can be pre-charged with compressed air up
to a maximum pressure of 150 psi (10.3 bar). If maximum pressure will exceed 150 psi (10.3 bar), dampener must
be pre-charged with Nitrogen only. Use a hand pump, Nitrogen tank or air compressor to charge dampener. DO
NOT USE OXYGEN. Charging hose kits are available from BLACOH.
The dampener must be pre-charged after installation but prior to system operation. The only method to get an
accurate pressure charge in the dampener is to charge it prior to system start up or with a closed isolation valve at
the dampener inlet. Pre-charge the dampener with 90% to 95% of expected system pressure. DO NOT USE
OXYGEN. A fill valve similar to a Schrader type tire valve but designed for suppressors, is mounted to the top of
the dampener. Replace fill valve cap after charging dampener and re-check dampener charge every month.
I
NSTALLATION FOR
W
H
ATER
AMMER
SURGE SUPPRESSOR
ISOLATION
VALVE
PUMP
BLACOH F
C
LUID
ONTROL
S
/
URGE
BLACOH
QUICK CLOSING
VALVE
10 PIPE (Ø)
, I
.
NC
R
B
I
EAD
EFORE
NSTALLATION
F
2
I G U R E
8