Disc Makers ElitePro Gebruikershandleiding - Pagina 11

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Disc Makers ElitePro. Disc Makers ElitePro 13 pagina's. Elite series

ElitePRO Getting Started Guide

Note: If these operations do not proceed as described, check the Problem Solving

section or the Troubleshooting FAQ for suggestions as to how to proceed.

Problem Solving

Refer to this list of common problems if you have trouble getting through this

Getting Started Guide. You can also consult the Troubleshooting FAQ in the User

Guide for additional information or use any of the support options listed at the end

of this guide.

Solving common problems

The duplicator won't power on.

The ElitePRO duplicator has two power switches—a master switch on the back of

the cabinet next to the AC power cord input and a power switch on the left side of

the cabintet. Ensure the master switch is in the On position (1) before pressing the

power switch on the left side of the cabinet.

The duplicator drops discs or won't pick them up from the spindles or trays.

Sometimes the alignment of the duplicator pick arm is affected during shipping. To

ensure that the pick arm is properly set up to move discs from point to point, refer

to the procedure titled Setting positions in the User Guide.

The duplicator repeatedly rejects the blank discs that I'm trying to use in copy

operations.

Make sure that you're using recordable CD discs with a CD master and record-

able DVD discs with a DVD master. Also, the quality of the media and the selected

recording speed can affect the rejection rate. Try using higher quality media (such

as Disc Makers recordable discs) or setting the maximum recording speed lower

during copy operations.

The duplicator robotics will not complete operations as directed and sometimes

the movements of the pick arm are erratic.

The optical sensors contained in the duplicator can be affected by very strong

light—either direct sunlight or strong artiﬁcial light. Try moving the unit to a loca-

tion that is not as bright to see if this resolves the problem.

When I try to run FlexWare, a message appears saying that the Autoloader has not

been detected and the software won't start.

FlexWare must be able to recognize the Autoloader each time the program starts.

Check to make sure that all cables are properly connected and restart the system. If

this doesn't work, try reinstalling the software from the FlexWare installation disc.

ElitePRO_Getting_Started_03.indd 11

2/20/06 4:40:09 PM