Disc Makers Elite PowerPro Installatie- en installatiehandleiding - Pagina 6

Blader online of download pdf Installatie- en installatiehandleiding voor {categorie_naam} Disc Makers Elite PowerPro. Disc Makers Elite PowerPro 7 pagina's. Elite series powerpro thermal printer

Pagina afdrukken

With the printer set up, follow these steps to allow final set-up:

When the ACC is opened, click on Run Diagnostics and allow

the loader and printer to cycle. Once complete all the areas

should be green.

If any of the circles are RED, STOP DO NOT CONTINUE

until steps are taken to correct the issue.

If all are GREEN then click on the Comm Center folder.

Open the ACC (Autoloader Control Console) this will allow the printer to be aligned.

Elite Setup Guide- Thermal Printer

When the Comm Center folder is displayed, click on

Calibrate. The unit will run through a calibration and

stop.

Place CDRs or DVDRs into the input spindle and click

on Print from input. Watch very carefully and when the

CD pick up device places the CD onto the printer,

observe the alignment. Move the printer tray until the

CDR is placed onto the center of the print tray. Run

more test input cycles and

operates.

Once the printer and tray is aligned:

1) Tighten rear thumb screws

2) Carefully remove printer & tighten front thumb screw

3) Replace Printer

4) Now you are ready to print

(If the alignment is not correct STOP and correct or you

may damaged media and possibly the PRINT HEAD)

observe how the unit