Blade 350 QX3 Gebruiksaanwijzing - Pagina 14

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Blade 350 QX3. Blade 350 QX3 16 pagina's.
Ook voor Blade 350 QX3: Gebruiksaanwijzing (16 pagina's)

Pagina afdrukken

Graphic User Interface

If you need to update the ﬁ rmware in your quadcopter, download the PC user

interface* at http://www.bladehelis.com/ProdInfo/Files/350_QX_PC_Interface.zip

Follow the on-screen instructions for installation and operation.

This graphic user interface allows you to monitor systems, adjust system settings

and calibrate sensors.

Sensor Information Screen

• See status of all sensors and speed controls at a glance

• Check battery voltage and accelerometer operation

Calibration Screen

• Calibrate accelerometers and camera gimbal

• Review instructions for compass sensor and DX4 transmitter calibration

• Adjust geo-referenced ﬂ ight boundaries

Troubleshooting

Problem

350 QX3 will not initialize

GPS will not lock

GPS has reduced resolution

GPS functions not operating

properly

Motors won't start

Blinking yellow led

'compass error' indication

Steady beeping,

motors won't start

Won't hold position in hover

Motors take a long period of

time to shut off after completing

return to home

Possible Cause

The quadcopter was moved during initialization

Heavy overcast

Solar ﬂ ares

Aircraft is indoors

Objects blocking clear access to the sky

(under a metal cover, inside a car, tall buildings, etc...)

Video transmitter nearby

Raised threat level by the U.S. government

The GPS antenna coaxial cable is nicked, cut,

or otherwise damaged

The compass has been exposed to a magnet

The GPS antenna coaxial cable is nicked, cut, or otherwise

damaged

The aircraft is behaving erratically

Aggressive ﬂ ight

GPS lock has not been acquired

'Compass error' is indicated by the LED

Incorrect start up procedure

Model is too close to a metal object or metal surface

Compass needs calibration

Throttle trim is not centered

Weak GPS signal

Compass needs calibration

Accelerometers need calibration

Pressure calibration is needed

GPS Screen

• See number of available satellites and signal strength

• Verify latitude, longitude and altitude indications

• Verify GPS accuracy

Device Information Screen

• See programming software version

• See quad ﬁ rmware version and vehicle ID

• Update ﬁ rmware

*Requires USB Interface (BLH7840) sold separately.

Re-arm the aircraft, being cautious to avoid any movement during

initialization

Wait for lighter cloud cover and re-lock or disable GPS

Wait for disturbance to subside or disable GPS

Disable GPS

Move aircraft to a clear area

Re-position or remove video transmitter

Wait for threat level to be reduced or disable GPS

Replace the GPS antenna

Move the aircraft away from the magnetic source. In worst case

scenario, the compass may need to be replaced

Replace the GPS antenna

Rebind the aircraft with the GPS function off

Fly level for a few seconds before using other modes

Ensure GPS antenna has clear view of sky and GPS lock has been

acquired

See below for troubleshooting 'compass error'

Review start up procedure in manual

Move model away from large metal objects or surfaces

Calibrate compass

(see calibration reference)

Calibrate DX4 transmitter

(AP or RTF version)

Center throttle trim (BNF version)

Check GPS antenna mast is extended

Calibrate compass

(see calibration guide)

Calibrate accelerometers

(see calibration guide)

Refer to the Pressure Sensor Calibration section of this manual

Solution