Armytek WIZARD C2 Gebruikershandleiding - Pagina 3
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Armytek WIZARD C2. Armytek WIZARD C2 4 pagina's. Multi flashlight
Pagina afdrukkenInitial Service
TO SET/REPLACE BATTERY
1. Unscrew the tailcap.
2. Place the battery with the positive contact (+) facing the head of the
flashlight.
3. Adjust the tailcap and tighten it as far as it can go.
The flashlight is ready for operation.
HOW TO CONNECT THE MAGNETIC CHARGER
Unscrew the tailcap for 1/4 of a circle and adjust the magnetic charger
to the tailcap.
CHARGER COLOR INDICATION
Charger not plugged in:
• Green — device is in waiting mode.
Charger plugged in:
• Green blinking — evaluation of battery voltage.
• Red blinking — unscrew the tailcap for 1/4 for charging.
• Orange blinking — USB power source voltage is too low for correct
continuation of charging or bad contact between charger and battery.
Try cleaning the tailcap and the threads of the flashlight parts or use a
different power source.
• Red — charging is going on, charging current is 1A.
• Orange — USB power source voltage is too low, charging current has
been reduced by half.
• Green — charging is finished.
REV_00-0000
Operation
Before use: Tighten the tailcap.
In OFF state:
1 click: To turn on the last used mode.
Press and hold: To start cycling through Firefly modes. Release to
select. Keeping button pressed will start cycling through Main modes.
In ON state:
1 click: To turn off the flashlight.
Press and hold: To start cycling through Main modes from any mode. In
Firefly1 cycling through Main modes starts after cycling through Firefly
modes. Release to select.
2 clicks: To turn on Turbo mode from any mode. The second double click
brings back last used mode.
MOMENTARY ACCESS
Firefly. Press and hold the button in OFF state to start cycling through
Firefly modes. Release to select. Keeping button pressed will start
cycling through Main modes.
Main. Short click from OFF state activates Main mode if it was the last
used mode.
Turbo. Double click in any mode in ON state. The second double click
brings back last used mode.
Cycling through Main modes. In ON state press and hold the button
in any mode. Main modes will start switching cyclically. In Firefly1
cycling through Main modes starts after cycling through Firefly modes.
Release to select.
Automemorizing. After switching off the last used mode is memorized
for quick access at next switching on.
Active temperature control. When the temperature of the flashlight
becomes close to 58 °С, brightness decreases to safe value, allowing
the flashlight to avoid overheating for a long period of time. In condi-
tions of good air-cooling the flashlight delivers light without stepping
down.
Low battery level. When the brightness is approximately <25% from
the nominal value, the LED will flash 2 times. If you are not sure wheth-
er or not it flashed, switch the flashlight
off and on: in case the battery is low, the flashes will repeat after 30 sec
from switching on. At critical level light output decreases to Firefly1."
Lock-out function. Unscrew the tailcap to 1/4 for the protection from
accidental switching on. State Indication will be turned off.
WIZARD C2 USER MANUAL ENG
3