Acorn Safety S2340-BF Instructies voor installatie, bediening en onderhoud - Pagina 3

Blader online of download pdf Instructies voor installatie, bediening en onderhoud voor {categorie_naam} Acorn Safety S2340-BF. Acorn Safety S2340-BF 4 pagina's. Barrier free combination stations

Pagina afdrukken

Installation & Operation Manual

INSTALLATION INSTRUCTIONS:

Supplies required: (not supplied by Acorn)

1. Floor fastener anchors, washers and bolts.

2. Pipe sealant or Teflon tape for sealing water connections.

IMPORTANT: Flush water supply lines prior to

connection to safety equipment.

Notes:

Top of spray nozzles must be between 33" - 45" from

finished floor in order to meet ANSI Z358.1.

Bottom of shower head must be between 82" - 96" from

finished floor in order to meet ANSI Z358.1.

Use hand tools and wrenches in a manner which will

prevent marring finished surfaces. Strap wrenches or tools

with plastic jaw linings are highly recommended.

Refer to Rough-in for location of supply and drain lines.

Fragments of Teflon tape or pipe sealant residue can

interfere with the proper operation of this unit. Ensure pipe

sealant methods do not cause contamination in the system.

Prior to beginning assembly, TURN OFF water supply to 1-

1/4" potable water supply line.

Step One: Pedestal

1. Locate and assemble components " A, B & C" to create

freestanding pedestal base using proper plumbing

techniques to seal all made up threads.

2. Position center of pedestal assembly a minimum of 0'-9"

from left and rear wall. Position from center of assembly a

minimum of 0-11" from right side of wall.

3. While holding the assembly in position, mark floor flange

mounting holes positions.

4. Remove assembly and install appropriate floor anchors to

receive mounting bolts (supplied by others).

5. Re-position assembly and install mounting bolts and

washers.

Step Two: UPPER SHOWER ASSEMBLY

1. Assemble components "D, E, F, G & H" to pedestal

subassy in sequential order using proper plumbing

techniques to seal all made up threads.

2. Ensure that fittings are aligned and perpendicular as

shown to allow for later stages of assembly.

3. Assemble components "I & J" in a similar manner.

4. Assemble component "K" to valve with clips provided.

Step Three: SUPPLY AND SANITARY DRAIN

CONNECTION

Note: Refer to Rough-In for supply and drain line locations.

1. Install necessary pipe fittings (supplied by others) to make

connection to 1-1/4" NPT waste tee with sanitary drain

line.

2. Install necessary pipe fittings (supplied by other) to make

connection to 1-1/4" NPT supply tee w/ potable water

supply line.

Acorn Safety

a division of Acorn Engineering

Manual #7109-260-001

Step Four: TEST

1. Verify 1/2" supply valve for eye/face wash and 1" supply

valve for shower are turned OFF.

2. Turn on water supply to 1-1/4" potable water supply.

3. Inspect system for leaks.

4. Verify shower and eye/face wash flow properly.

Step Five: Signage and Inspection

1. Install sign "L" with clear visibility as shown, with

appropriate hardware (supplied by others).

2. Attach inspection tag "M" supplied, with plastic zip tie 1/2"

supply line as shown.

UPPER SHOWER

SUBASSY

CONNECTION FITTINGS

PEDESTAL

SUBASSY

(4) MTG SCREWS & HARDWARE

(PROVIDED BY INSTALLER)

SANITARY LINE CONNECTION

Company

™

Page 3 of 4

SUPPLY LINE

PROVIDED BY OTHERS

FITTINGS (PROVIDED BY

INSTALLER)

Date: 05/07/13