Discount Car Stereo A2DIY-GM3X Beknopte installatiehandleiding - Pagina 3

Blader online of download pdf Beknopte installatiehandleiding voor {categorie_naam} Discount Car Stereo A2DIY-GM3X. Discount Car Stereo A2DIY-GM3X 8 pagina's. For gm class ii with rse and/or xm module

Pagina afdrukken

4. If NOT retaining XM (Expired subscription):

Connect male-to-male cable audio cable (See Fig. 4) to module "AUX"

jack (See Fig. 5)

3.5mm male to male cable

Fig. 5

Module

5. Secure microphone (See Fig. 6) to visor or headliner using included

visor clip (See Fig. 7)

Fig. 6

Microphone

6. Route microphone cable (10 ft.) down pillar, under driver kick panel and

across to radio cavity and connect to module "MIC" jack (See Fig. 5)

Be cautious not to damage or cut both microphone cable.

Fig. 4

Fig. 7

Visor clip

red

7. Connect installation harness

Do not connect red wire to 12V constant supply (battery).

Tip: There is no accessory (ACC) wire on GM radio harness. Locate suitable 12V

supply in fuse panel. Accessory power is active when ignition is in "ACC" or

"ON "positions.

8. Connect Black wire with ring terminal to radio chassis by removing chassis

screw and secure ring terminal or simply ground to alternate location.

Please black wire is properly grounded otherwise module will not properly

power on.

Warning: The A2DIY-GM3x will not operate in RAP (Retained

Accessory Power) mode. Ignition must be "ON" during calls,

streaming applications or for RSE/XM (if subscribed) to be heard.

For module to work in RAP mode we recommend purchasing our

. Connecting the TR-4 green wire to any radio speaker output wires

will allow module to remain "ON" up and until radio is turned off.

wire to 12V accessory supply in vehicle.

TR-