BLADEZ PB-SE802 Handboek - Pagina 12
Blader online of download pdf Handboek voor {categorie_naam} BLADEZ PB-SE802. BLADEZ PB-SE802 18 pagina's. Gas powerboard powered personal transportation
Pagina afdrukken
- 1. Engine Oil
- 2. Table of Contents
- 3. Getting to Know Your Bladez Power Board
- 4. Package Contents
- 5. Getting Started
- 6. Folding and Storage
- 7. Operating Procedures
- 8. Maintenance
- 8. Recommended Tools
- 8. Carburetor Adjustment
- 8. Braking System
- 8. Tires and Wheels
- 8. Adjusting the Head Unit
- 8. Adjusting the Belts
- 9. Maintenance Schedule
- 10. Other Questions
MAINTENANCE
RECOMMENDED TOOLS
To adjust and service the Bladez MOBY Power Board you will need the following
tools:
Allen Wrenches:
Wrenches:
Short reach Spark Plug Socket
Large Adjustable Crescent Wrench
Spark Plug Sockets
Philips Head Screwdrivers
Oil, Grease or Lubricant (such as WD-40)
CARBURETOR ADJUSTMENT
WARNING!
Never start the engine without the complete clutch cover assembled!
Otherwise the clutch can come loose and cause personal injuries.
In the Carburetor, fuel is mixed with air. When the engine is test run at
the factory, the Carburetor is basically adjusted. A further adjustment
may be required from time to time, depending on climate and altitude.
The Carburetor has only one possible adjustment:
T= idle speed adjustment screw
Idle Speed Adjustment (Fig. 9)
When the idle speed is adjusted properly, the engine will run smoothly,
without pressing the THROTTLE LEVER.
3 / 4 / 5 / 6mm.
10 / 13 / 16 mm Open and ring combination.
If adjustment is required:
1. Start the engine.
2. Using a long, Philips head screwdriver
gently close (clockwise) the T-screw
until the MOBY starts to move forward.
3. Then open (counter-clockwise) the
screw until the MOBY stops.
4. You have reached the correct idle speed
when the engine runs smoothly below
the RPM when the MOBY starts to
move.
Note: Standard idle RPM is about 2500-
3000 RPM.
Page 12 of 18