Cub Cadet 190- 670-100, 190-678-100 Gebruikershandleiding - Pagina 7
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Cub Cadet 190- 670-100, 190-678-100. Cub Cadet 190- 670-100, 190-678-100 12 pagina's. Cub cadet twin rear bagger kit operator's manual
Pagina afdrukken
SECTION 3: ASSEMBLY & OPERATION
NOTE: References to LEFT, RIGHT , FRONT and
REAR of the tractor are from the operator's position.
•
Before assembly, place the tractor on a firm and
level surface, disengage the PTO, stop the tractor
engine and set the parking brake.
Mounting Bracket Assembly
NOTE: For convenience, pivot the seat forward and
leave it in that position until the grass collector is fully
mounted and assembled.
•
Remove the hairpin clip and clevis pin from the rear
of the mounting bracket assembly.
•
Position the hooked ends of the bracket assembly
to the outside of the hitch plate and over the
shoulder bolts. See Figure 2.
Mounting
Bracket
Hitch Plate
Figure 2
•
Reinsert the clevis pin through the aligned holes in
both the bracket assembly and the hitch plate and
secure with the hairpin clip. See Figure 3.
Clevis
Pin
Hairpin Clip
Figure 3
IMPORTANT:
sure to insert the hairpin clip in the upper hole to
properly secure the bracket assembly to the hitch plate.
Attaching the Grasscatcher Cover and Bags
•
Slide the support tube down through the holes in
the left side of the mounting bracket assembly. Use
the inside hole on the bracket assembly regardless
of what size deck your tractor is equipped with. See
Figure 4.
Shoulder
Holes
Bolt
•
Place the grasscatcher cover assembly in position
so that the support tube rests on the right side of
the mounting bracket assembly. Allow the plastic
cover to rest in the "open" position . See Figure 4.
Align these
holes
7
There are two holes in the clevis pin. Be
Support
Tube
Mounting
Bracket Assembly
Figure 4
Slots
Slots
Figure 5
Clevis Pin
Bell Washer
Click Pin