3D Fun Printz Universal Pen Holder Snelstarthandleiding
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} 3D Fun Printz Universal Pen Holder. 3D Fun Printz Universal Pen Holder 3 pagina's.
Pagina afdrukken
Universal Pen Holder Instructions
Thank you for purchasing the 3D Fun Printz Pen Holder
There are some tips below to get the best out of it.
Most importantly. The Pen Holder is partly made from PLA as it is a natural plastic
originating from corn starch and is recyclable. For these reasons it does not like heat.
Please don't leave it in the sun, on a hot windowsill, on or near a radiator or anywhere else
with a lot of heat.
Please also keep away from children and animals. PLA can be sharp when broken.
NEVER TRY AND ADJUST THE SCREW CAP WHILE THE HOLDER
IS IN YOUR MACHINE. YOU WILL DAMAGE YOUR MACHINE.
ALWAYS FULLY REMOVE THE HOLDER BEFORE ADJUSTMENT
To fit a pen into the holder clip the alignment clip onto the holder as shown. It should
remain loosely in place without holding. There are tabs that fit into the holes on the pen
holder