ARO 7149-C Gebruikershandleiding

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} ARO 7149-C. ARO 7149-C 12 pagina's. “22” series short grinders

Pagina afdrukken

OPERATOR'S MANUAL

SECTION

M10

MANUAL

Released:

5/79

INCLUDING: OPERATION, INSTALLATION & MAINTENANCE

"22" SERIES SHORT GRINDERS

Revised: 1 O-20-95

Form:

1566-2

Models:

7149-C, 7153-C,

7235-C and 7236-C

READ THIS MANUAL

CAREFULLY

BEFORE

INSTALLING,

OPERATING

OR SERVICING

THIS EQUIPMENT.

FAILURE TO OBSERVE

THE FOLLOWING

WARNINGS

COULD RESULT IN INJURY.

To aid the operator's understanding of proper and safe use of

grinders, the publications, "Use, Care and Protection of Abrasive

Wheels", A.N.S.I. B7.1, and "Safety Code for Portable Air Tools",

A.N.S.I. B186.1, can be purchased from:

American National Standards Institute, Inc.

1430 Broadway

New York, New York 10018

Operate this tool at 90 p.s.i.g. (6.2 bar) maximum air pressure

at the air inlet of the tool..

Disconnect air supply from tool before removing/installing

wire brush or rotary file or performing other maintenance pro-

cedures.

Keep hands, clothing and tong hair away from rotating end of

tool.

Anticipate and be alert for sudden changes in motion during

start up and operation of any power tool.

Never exceed rated r.p.m. of tool.

Wear suitable eye and hearing protection while operating tool.

Tool shaft can continue to rotate briefly after throttle is re-

leased.

Do not lubricate tools with flammable orvolatile liquids such as

kerosene, diesel or jet fuel.

Use tool only for purposes for which it was intended.

Do not use excessive work pressure.

Do not remove any labels. Replace any damaged label.

Use only accessories recommended by ARO.

Repeated prolonged operator exposure to vibrations which may

be generated in the use of certain hand-held tools may produce

Raynaud's phenomenon, commonly referred to as Whitefinger

disease. The phenomenon produces numbness and burning

sensations in the hand and may cause circulation and nerve dam-

age as well as tissue necrosis. Repetitive users of hand-held

tools who experience vibrations should closely monitor duration

of use and their physical condition.

The use of other than genuine ARO replacement parts may

result in safety hazards, decreased tool performance and in-

creased maintenance and may invalidate all warranties.

ARO is not responsible for customer modification of tools for

applications on which ARO was not consulted.

Tool maintenance and repair should be performed by autho-

rized, trained, competent personnel. Consult your nearest

ARO authorized servicenter.

It is the responsibility of the employer to place the information

in this manual into the hands of the operator.

For parts and service information, contact your local ARO distributor, or the Customer Service Dept. of the Ingersoll-Rand Distribution

Center, White House, TN at PH: (615) 672-0321, FAX: (615) 672-0801.

-0

ARO Tool Products

Ingersoll-Rand

Company

1725 U.S. No. 1 North

P.O. Box 8000

Southern Pines, NC 283888000

PRINTED IN U.S.A.

Part of worldwide Ingersoll-Rand