3D Nord magicolor 2300W Installatiehandleiding - Pagina 15

Blader online of download pdf Installatiehandleiding voor {categorie_naam} 3D Nord magicolor 2300W. 3D Nord magicolor 2300W 19 pagina's.

Safety Information

Toner

Do not throw the toner cartridge or toner into an open flame. The hot toner may

scatter and cause burns or other damage.

CAUTION: Keep out of reach of children.

International Notices—Power Cord

The following power cord requirements are in effect for your 220~240 V ±10% printer.

Minimum: 0.75 mm

Minimum: H05 VV - F

The male plug is certified in the country in which the equipment is to be installed, and the

female plug is an IEC 60320 connector.

International Notices—Voltage

Attention Norwegian users: This equipment is designed to operate within an IT power system

where the line-to-line voltage does not exceed 240 V.

During printer operation, a small quantity of ozone is released. This amount is not large

enough to harm anyone adversely. However, be sure the room where the printer is being

used has adequate ventilation, especially if you are printing a high volume of materials, or if

the machine is being used continuously over a long period.

This printer is a page printer which operates by means of a laser. There is no possibility of danger from the

laser, provided the printer is operated according to the instructions in this manual.

Since radiation emitted by the laser is completely confined within protective housings and external covers,

the laser beam cannot escape from the machine during any phase of user operation.

This printer is certified as a Class 1 laser product under the U.S. Department of Health and Human

Services (DHHS) Radiation Performance Standard according to the Radiation Control for Health and

Safety Act of 1968. This means that the printer does not produce hazardous laser radiation.

Maximum Average Radiant Power: 4.68 mW at the surface of the OPC drum

Wavelength: 770–795 nm

This product employs a Class IIIb Laser Diode that has an invisible laser beam. The Laser Diode and

Scanning Polygon Mirror are incorporated in the print head unit. The print head is in the interior of the

printer in front of the toner cartridge. The laser beam is emitted from the print head unit, and then is

radiated through the laser aperture to the interior of the printer.

Safety Information

EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500