Acoustech H-100II Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Acoustech H-100II. Acoustech H-100II 12 pagina's. 12 inch powered subwoofer

Pagina afdrukken

SUBWOOFER CONNECTION-METHOD B

Connecting to Receivers with NO SUBWOOFER or LFE Output Jack

If your receiver does not have a low level SUBWOOFER or LFE output jack (for example, older Dolby Pro Logic receivers or

stereo-only integrated amps), you will use the method shown below in Drawing D to connect your subwoofer to the receiver.

For this connection, you will need speaker wire to run from your receiver to sub (for subwoofer HIGH LEVEL INPUTS), and then

from the sub to speakers (for OUTPUT TO SPEAKERS). Speaker wire can be purchased at the majority of electronics and audio

stores. We recommend 16-18 gauge wire. The lower the number gauge, the thicker the wire is. For longer runs, use thicker

wire. Make sure the length of your wire is long enough to give a little bit of slack to for some placement flexibility.

HOOKUP STEPS

DRAWING D

Connecting with Speaker wire to HIGH LEVEL Inputs and Outputs.

1. IMPORTANT: Make sure that ALL stereo

system components including the subwoofer

are turned OFF before proceeding.

2. Measure the length of wire you will need,

and then cut and strip ½˝ of the insulation

from each end of the four wires you will run

for hookup.

3. Locate the front left and right main speak-

er terminals on the rear of your receiver and

connect two wires to these terminals.

4. Route the speaker wire to the subwoofer

location (trying to minimize areas where it

may be stepped on). Connect the other ends

of the speaker wire directly to the HIGH

LEVEL INPUTS FROM AMPLIFIER #1.

Make sure the left and right wires are hooked

to the proper left and right channel and that

all (+) terminals go to (+) terminals and all (-

) terminals go to (-) terminals. Most speaker

wire has some marker to help you keep track

of the polarity such as color coding or writing.

5. Connect the two remaining speaker wires

from OUT TO SPEAKERS #2 to your main

left and right speakers. As in step 4 above,

make sure the left and right channels and (+)

and (-) polarity are correct.

6. Connect the included power cord to the

POWER INPUT (#3) on the back of your

H-100II. Then connect its plug to an AC

outlet ONLY. Since your H-100II draws a

moderately high amount of current, we do

not recommend plugging it into a "conve-

nience" outlet (switched or unswitched)

found on the back of receivers and other

stereo components.

7. Set the CROSSOVER FROM DIGITAL

RECEIVER OR SUB SWITCH (#4) to the

"Pro Logic Receiver" position (on right). This

will enable you to set the crossover from your

subwoofer with the CROSSOVER FRE-

QUENCY CONTROL (#5) on the back of

your H-100II (also see Page 5, #5). In most

cases, setting the crossover to the 90Hz set-

ting on the control will yield the best results.

8. Set the PHASE SWITCH (#6) to 0°.

You will later need to follow instructions on

Page 5, #3 for room settings.

9. You are now ready to turn your POWER

switch (#7) on and enjoy the deep bass

you have been waiting for. You can learn more about the "auto" feature on this switch on Page 5, #2.

10. See Page 9 for "Initial Listening Test".