Disney MK-320 Snelstarthandleiding
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Disney MK-320. Disney MK-320 2 pagina's. Rockin’ ride alarm clock
Pagina afdrukkenInstalling the Batteries
ATTENTION: Batteries should only be installed by an adult.
The unit comes with batteries already installed. These batteries are meant
for in-store demonstration use only, and should be replaced with fresh
batteries when you get the toy home. A Low Battery icon will appear on
the display when batteries need to be replaced.
To replace the batteries:
1. Using a Phillips screwdriver, open the battery compartment door
located on the back of the unit.
2. Insert 3 new AA (R6) batteries in the battery compartment. Make
sure batteries match the + and – as indicated in the battery
compartment diagram.
3. Close battery compartment door. Do not overtighten screw.
WARNING DO NOT DISPOSE OF BATTERIES WITH HOUSEHOLD
TRASH. PLEASE CONSULT LOCAL REGULATIONS FOR PROPER
BATTERY DISPOSAL.
For the Best Possible Performance
•
We recommend the use of alkaline batteries for longer life.
•
Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
•
Batteries are to be inserted with correct polarity.
•
Remove exhausted batteries from the unit.
•
Do not attempt to recharge non-rechargeable batteries.
•
Remove the rechargeable batteries from the unit before charging.
•
The supply terminals are not to be short-circuited.
•
Batteries should be removed if the item will not be used for an
extended period of time, such as a month or longer, to prevent
battery leakage or damage.
•
Rechargeable batteries should only be charged under adult
supervision.
•
Only batteries of the same or equivalent type recommended are to
be used.
Unpacking and Set Up
The Unit has a demo tab for in-store demonstration purposes. Make sure
to remove this tab. To do so, gently pull on tab. Dispose of tab properly.
Remove the clear protective film from the clock display.
Alarm Indicator
Low Battery Indicator
PM Indicator
1
3
Battery Installation
Alarm ON/OFF Switch
Music Button
Alarm Set Button
Clock Set Button
Snooze/Light Button
Clock display
Demo Tab
Reset Port
Reset Button
Bottom View
Settings Up & Down Buttons
Setting The Time
•
Press and hold the Time Set Button until the display
flashes.
•
Press the
or
Button to adjust the clock to the
current time (hold to set more rapidly). Make sure to set the
correct AM or PM time. The PM indicator appears to the
lower left of the time display; there is no AM indicator.
•
Press the Time Set Button to confirm time setting.
Setting the Alarm
Set the Alarm On/Off Switch to "ON" to wake up to sound
effects, music and Mickey's voice, and set to "OFF" to
disable the alarm.
•
Press and hold the Alarm Set Button until the display
flashes.
•
Press the
or
Button to adjust the display to the
desired alarm time (hold to set more rapidly). Make sure to
set the correct AM or PM time. The PM indicator appears to
the lower left of the time display; there is no AM indicator.
•
Alarm is active when the
icon appears on the display.
•
Press the Alarm Set Button to confirm alarm setting.
Snooze, Display Light and Alarm Reset
Press down on the Snooze Button when the alarm sounds to
snooze the alarm for about 9 minutes. After this, the alarm will
sound again. You can press the Snooze Button several times
during the duration of the alarm (about an hour).
Pressing the Snooze Button when the alarm is not sounding
will turn on the display backlight briefly.
Press the Alarm Set Button to stop a sounding alarm and reset
it to come on the next day at the same time.
Music Button
Press the Music Button to listen to music with Mickey Mouse.
Press the Music Button again to listen to the next Mickie
Mouse song.
Press the Music Button again to exit and turn off the sound.