Abbott Heartmate 3 Snelstarthandleiding - Pagina 4

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Abbott Heartmate 3. Abbott Heartmate 3 4 pagina's. Left ventricular assist system

Pagina afdrukken

GREEN

Troubleshooting HeartMate 3™ LVAS

Changing the System Controller

Step 1: Have the patient sit or lie down since the pump will

momentarily stop during this procedure.

Step 2: Place the replacement Controller within easy

reach,along with the batteries/battery clips. The

spare Controller is usually found in the patient's

travel case.

Step 3: Attach the battery clips to the replacement

controller by lining up half circles, firmly pushing

together, and tightening connector nut. Insert the

batteries into the clips by aligning the

Step 4: On the back of the replacement controller,

slide the safety lock so the red release button

is fully visible. Repeat this step on the original

controller.

Step 5: Disconnect the drive-line from the original

controller by pressing the red release button and

pulling it out. The pump will stop and an alarm

will sound. Note: The alarm will continue until the

original controller is turned off. You can silence

the alarm by pressing the silence alarm button.

Getting the replacement controller connected

and the pump restarted is the ﬁrst priority!

Step 6: Connect the replacement Controller by aligning the

WHITE ARROWS on the driveline and replacement

Controller and firmly pushing the driveline into the

replacement Controller. The pump should restart, if

not complete the following steps:

Firmly press the Silence Alarm or Battery

Button to restart the pump.

Check the power source to ensure that power

is going to the controller.

Ensure the driveline is fully inserted into the

socket by gently tugging on the metal end.

DO NOT pull the driveline.

Step 7: After the pump restarts, slide the safety lock

on the new controller so the red release button

is fully covered. If unable to close the safety

lock into fully locked position, gently push the

driveline into the controller to ensure proper

connection. Retry to close safety lock.

Step 8: Disconnect power from the original Controller.

Step 9: Hold down battery symbol for 5 full seconds for

complete shutdown of old controller.

GREEN

RED

arrows.

GREEN

Step 3

Step 4

Step 5

Step 6

Step 9

This guide does not supersede manufacturer instructions.

GREEN

Step 7