Aerial AD 430 Gebruiksaanwijzing - Pagina 8

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Aerial AD 430. Aerial AD 430 16 pagina's.

6.2 Putting into operation

ATTENTION:

Before putting the air dryer into operation, the instruction manual should be studied

carefully. Thus, damages by a false or inappropriate operation as well as by

inadequate environmental conditions can be avoided.

For using the air dryer, please proceed as follows:

After having been transported, the air dryer should rest for about 15 min. During

this period of time, the oil inside the refrigerating system, that was foamed

during transport will return into the compressor. We recommend this procedure

since it extends the service life of the compressor.

Connect the equipment plug of the main cable with the equipment plug socket of

the unit (see 1.3 – pos g) )

Put the plug into a suitable socket.

Check whether the bucket is placed in the unit or a drain hose has been

fastened and laid appropriately.

Switch on the unit by actuating the ON-OFF-switch.

Set the required humidity value at the hygrostat (please refer in this respect to

'Hygrostat Control' - 5.4).

If the existing humidity is higher than the set value, the air dryer will start to

operate.

If the existing humidity is lower than the set value, the air dryer will not start to

operate.

6.3 Operation panel

On-/Off-switch

neon:

tank full

Hygrostat (se

hygrostat control

6.4)

Operation time

counter

page 8 of 16