3D Systems FabPro 1000 Setup

Blader online of download pdf Setup voor {categorie_naam} 3D Systems FabPro 1000. 3D Systems FabPro 1000 4 pagina's.

FabPro 1000 Setup

Please see the FabPro 1000 User Guide, found on support.3dsystems.com/fabpro, for safety information and com-

prehensive operating instructions.

Save all foam and packing material for future use. Shipping without the original packing material may

cause damage to the printer.

1. Remove Finishing Kit

Remove packed-in documents (1),

finishing kit (2), and power cord

box (3). Compare the contents of

the printer package to the list in

the

Welcome Letter

to ensure

everything is included.

4. Stage Printer

Team-lift printer off pallet and onto

table/counter. Remove protective

covers from LCD screen (1) and printer

door (2). Remove plastic packaging

and silica-gel packet (3).

Ensure staging area is on a level

surface.

2. Mix Material Bottle(s)

Mixer sold separately

Place bottle(s) on LC-3DMixer for time

specified on material's package or

shake bottle vigorously up and down.

Stir material in print tray before each

build (see

User

Guide).

Insufficiently mixed material

may result in build failure.

5. Install Glass Print Base and Print Tray

Open printer door. Remove foam piece from under the tilt tray.

Install glass print base in tilt tray, lining up its flat corners

with corresponding flat corners in tilt tray.

The print tray is wrapped inside the plastic storage container in the

finishing kit. Unwrap it. Install it, concave side facing upward. Be sure the

"FRONT" label is facing you.

Fasten four toggle case locks.

3. Remove Packing Material

Open all four box clips (1) along the

bottom of the package. Lift outer box

up and off (2). Remove foam pieces

from top of printer.