3D Systems Geomagic Touch Snelstarthandleiding - Pagina 5

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} 3D Systems Geomagic Touch. 3D Systems Geomagic Touch 5 pagina's. Haptic device

Pagina afdrukken

When the computer and device have been successfully paired – the notice below will appear.

10. Click OK, then press the

11. On the Desktop, click to open the

Touch>Geomagic Touch

12. Click the

arrow in the bottom right of the dialog or click the Select tab to move on to the next step.

13. The

Select

tab initializes the Geomagic Touch device and begins to run to the Servoloop. Click the Next arrow when the six

remaining test tabs appear in the dialog to move on to the Calibration stage.

14. You will have to move the stylus through the complete range of motion to properly calibrate the device. Once each axis is

calibrated, its icon will turn

15. Complete the remaining Geomagic Touch tests. When complete, click the red X in the top right corner to exit the Geomagic Touch

Diagnostic.

Go to

http://support.geomagic.com

3D Systems, Inc.

Apply

and

buttons in the Geomagic Touch Setup dialog.

Geomagic Touch Diagnostic

Diagnostic.

Green

(see image) when the device is properly calibrated.

to download the Geomagic Touch Device Guide.

Start>All Programs>3D Systems>Geomagic

or click