Acoustic Arc AAI-DS0820US0 Gebruiksaanwijzing - Pagina 6

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Acoustic Arc AAI-DS0820US0. Acoustic Arc AAI-DS0820US0 6 pagina's. 2.4g digital stereo wireless speaker system

Pagina afdrukken

TROUBLE SHOOTING

NO SOUND

Ensure the AC adapter is fully inserted into the AC outlet and the power connection input on the

transmitter.

Ensure the speaker is switch ON.

Speaker' s battery capacity is too low, replace with new batteries or connect the AC adapters to the

speakers.

Ensure the TV or audio component is ON.

The connected audio / video equipment is not playing. Start playing the equipment.

The volume of speaker is too low, adjust the volume to an appropriate level.

Re-start the pairing process again by pressing the "ID" button for 3sec. on the transmitter and

speakers. The pairing processes will be finished after hearing a " Do" sound.

DISTORTED

Press the " Pair" button on the speakers until matching the frequency of the transmitter.

Press the " Pair" button on the transmitter.

Battery capacity is too low. Replace with the new battery.

Ensure the volume level of speakers is adjusted properly.

The speaker is too far from transmitter, move closer.

The input level of the audio signal is too low. Turn up the volume of the audio source equipment.

TECHNICAL SPECIFICATIONS

Transmission Mode

Carrier Frequency

Operation Voltage

Frequency Response

Distortion

S/N Ratio

Channel Separation

Operation Distance

Output Power

WARNING :

Changes or modifications to this unit not expressly approved by the party responsible for

compliance could void the user' s authority to operate the equipment. Operation is subject to

the following two conditions: (1) this device may not cause interference, and (2) this device must

accept any interference, including interference that may cause undesired operation of the

device.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

UHF stereo

2.4G Digital

Transmitter, DC 6V 300mA adapter

Speaker,

DC 12V 1A

" C"size Alkaline batteries (not included)

Remote Control Unit, 2 X ' AAA' size green

batteries (included)

30Hz – 20KHz

0.5%

75dB (typical)

70dB (Typical)

Up to 150feet

2 x 5W (Max)

adapter

8 X