Acoustic Control GAMMA CUMULUS Gebruikershandleiding - Pagina 2

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Acoustic Control GAMMA CUMULUS. Acoustic Control GAMMA CUMULUS 2 pagina's.

Pagina afdrukken

DC 9V Power Input Jack

You can power your GAMMA Series

pedal from a 9-volt regulated DC

adapter (plug polarity is positive on the

barrel and negative in the center).

2. Battery Capability

Use a Phillips head screwdriver to

remove the 4 bottom screws to access

battery connection. High quality

alkaline 9-volt battery can be used for

approximately 4 hours of continual

operation. If pedal won't operate when

battery is installed, battery may be

discharged, and should be replaced

with a fresh, fully-charged battery. Or

connect a compatible power supply for

non-battery operation.

3. Footswitch

Push down the footswitch to toggle

between on and bypass status.

4. LED

When the LED is lit, the effect is on.

When it's off, the effect is bypassed.

(Bottom removed for battery access)

5. INPUT Jack

¼" mono audio jack, to receive the

signal from your guitar or a previous

pedal. Pedal draws power only when

this jack has a plug inserted.

6. OUTPUT Jack

¼" mono audio jack, outputs the signal.

MODE SWITCH

Select from the 3 modes:

• Studio emulates a recording studio

• Spring emulates a spring reverb

• Plate emulates a reverb plate

8. MIX Knob

Adjusts reverb from minimum, to 100%

"wet": at maximum, all the sound is

from the reverb, with no "dry" signal.

9. DECAY Knob

At low settings, the reverb time is short,

at high settings, the reverb time is long.

10. TONE Knob

Adjusts the reverb from dark to bright.

AcousticControlCorp.com

Underside of pedal

21510408 2209