3D Upfitters AnkerMake M5 Installatiehandleiding - Pagina 6

Blader online of download pdf Installatiehandleiding voor {categorie_naam} 3D Upfitters AnkerMake M5. 3D Upfitters AnkerMake M5 18 pagina's.

Assemble Panels

1. The Front Panel 

Each of the corners of the enclosure will be held together by the connectors pictured

below. Only two versions, L and R, can be identiﬁed by the letters stamped inside.

The opposite connectors are identical, i.e., the Bottom Right is the same as Top Left.

In all cases, the surface of the connector with the cutout pattern faces front or back.

The front door is designed so that the latches are on the left. Attach the corner

connectors on the back side of the door frame using the provided cap head 12mm

screws. See the photos below. The top of the connector should be ﬂush with the top

of the acrylic.

There are also smaller connectors at the top and right sides when viewed from the

front.

Top Left

Bottom Left

Top Right

Bottom Right