CAME Z Series Handmatig - Pagina 2

Blader online of download pdf Handmatig voor {categorie_naam} CAME Z Series. CAME Z Series 16 pagina's. Control board
Ook voor CAME Z Series: Handmatig (8 pagina's), Handmatig (20 pagina's), Handmatig (4 pagina's), Handmatig (4 pagina's), Handmatig (17 pagina's), Handmatig (17 pagina's), Handmatig (13 pagina's), Handmatig (13 pagina's), Handmatig (16 pagina's), Handmatig (12 pagina's), Handmatig (12 pagina's), Handmatig (18 pagina's), Installatiehandleiding (11 pagina's), Handmatig (8 pagina's), Handmatig (20 pagina's), Handmatig (12 pagina's), Handmatig (12 pagina's), Handleiding technische documentatie (16 pagina's), Gebruiksaanwijzing (16 pagina's), Instructies (4 pagina's), Beknopte handleiding (2 pagina's), Aansluithandleiding (4 pagina's), Handmatig (4 pagina's), Handmatig (12 pagina's), Handmatig (20 pagina's), Handmatig (15 pagina's), Gebruiksaanwijzing (12 pagina's), Snelstarthandleiding (12 pagina's), Handmatig (16 pagina's)

Pagina afdrukken

ENGLISH

Description of control board

The ZA4 control board is suitable for

controlling automation of ATI, FERNI

and FROG series 230V swing gates

with up to 600W power and 50-60Hz

frequency.

Wholly designed and built by CAME

S.p.A., it meets UNI 8612 regulations

in force. The board is inserted and

fixed to the ABS case (S4339 o

S4340), which has an IP54 protection

level, with air recycling inlet and

transformer.

The board requires 230V (a.c.) at

terminal blocks L1-L2 and the inlet is

protected with two 5A fuses. A 1A fuse

protects the low voltage command

devices.

The accessories' total wattage (24V)

must not exceed 20W.

Safety

Photocells can be connected to obtain:

- Re-opening during closure (2-C1), if

the photocells identify an obstacle

while the gate is closing, they will

reverse the direction of movement until

the gate is completely open;

- Total stop (1-2), shutdown of gate

movement without automatic closing; a

pushbutton or radio remote control

must be actuated to resume

movement).

-2-

GENERAL CHARACTERISTICS

- Flashing signal light when gate is in

motion 25W max. (E1-W):

- Radiofrequency «AF» board (see

table pag.7).

- Automatic closing. The automatic

closing timer is automatically activated

at the end of the opening cycle. The

preset, adjustable automatic closing

time is automatically interrupted by the

activation of any safety system, and is

deactivated after a STOP command or

in case of power failure;

- "Operator present" function: Gate

operates only when the pushbutton is

held down (the radio remote control

system is deactivated);

- Trimmer TL = Adjustment of operating

time;

- Trimmer TR2M = Delay on closing

cycle - motor 2;

- Trimmer TCA = Adjustment of

automatic closing;

Accessories which can be

connected to this unit

Other functions available

Adjustments

aution! Disconnect the unit from

the main power lines before carrying

out any operation inside the unit.