CAME PRATICO SYSTEM BX Series Installatiehandleiding - Pagina 5

Blader online of download pdf Installatiehandleiding voor {categorie_naam} CAME PRATICO SYSTEM BX Series. CAME PRATICO SYSTEM BX Series 19 pagina's. Automation for sliding gates

Pagina afdrukken

1- BX-P unit

2- Control board incorporated

3- Radio receiver

4- Limit-switch tabs

5- Rack

5.4 Motor to base anchorage

The following applications are only examples, as the space required for unit installation and the accessories vary de-

pending on dimensions and therefore it is up to the installer to select the best solution.

Install the screws in the anchor plate and fasten them with a nut, then bend the preformed clamps downwards.

Construct a cement foundation that is large enough to accomodate the gear motor (it is a good idea to protrude 50 mm. from the

ground). When pouring the foundation, embed the gear motor anchor plate and the relative clamps in the cement.

The anchor bolts should be embedded in the concrete in the positions indicated; the drive unit is then attached to this bots. The

anchor plate must be perfectly level and absolutly clean; the bolts threads must be completly exposed.

N.B.: The ﬂ exible tubes for the electrical wiring must be embedded in the base and protude in the correct position.

Fixing plate / Anchor stays

6- Key-operated selector switch

7- Flashing light indicating door movement

8- Antenna

9- Safety photocells

10- Photocell column

11- Closure stop

Rack-limit

Cables

Gate wing

Wall

Concrete base