CAME BPT AG2K200C03UK Installatiehandleiding - Pagina 7
Blader online of download pdf Installatiehandleiding voor {categorie_naam} CAME BPT AG2K200C03UK. CAME BPT AG2K200C03UK 16 pagina's.
Pagina afdrukken
HNA/102
A B C
Description
Access control module equipped with 2 relays that can be acti-
vated by codes keyed in on keypad.
Function of terminals and link
Terminal board M1 1
12÷16 VAC, 14÷18 VDC Power supply input
E n -
I1
trance
Entry panel contact
–
Ground
Terminal board M2 1
C1
Common
NC
Normally closed contact
NO
Normally open contact
C2
Common
NC
Normally closed contact
NO
Normally open contact
Function of SW1 link 1
Armed: Button illumination on.
Disarmed: Button illumination NOT on (default).
1
Type
Power supply (VAC)
Consumption with AC power supply (mA)
Consumption in stand-by mode
with AC power supply (mA)
Power supply (VDC)
Consumption with DC power supply (mA)
Consumption in stand-by mode
with DC power supply (mA)
Operating temperature (°C)
a) Up to 100 user codes can be stored. The codes can be of 3,
b) The module is equipped with 2 relays for services with the
- Programmable activation time for each relay (from 1 to 65
- Monostable or bistable operation for each relay;
- Option to lock in active status the relays in monostable op-
Relay contact 1
Relay contact 2
c) When a key is pressed, beeps are generated to confirm the
- Key pressed = short beep;
- Correct operation = long beep;
- Incorrect operation = three short beeps.
d) The status of the module and the functions in progress are
- green LED A can be programmed to be:
- yellow LED B,
Technical data
Available functions
4 or 5 figures, with a value from 001 to 65535. Each code
can be associated to one of the 2 relays.
following operating features:
seconds);
eration, by pressing the
runs out (to deactivate it re-enter the same code); relay 2
can if necessary be associated to an alarm or bell activation
service (by first enabling function 09).
Activation of the alarm
Relay 2 is activated by pressing
deactivate it see function 10).
All the user codes associated to relay 1 are enabled upon
activation of the alarm.
Activation of the bell
Relay 2 is activated only by pressing
alarm signal being sent inadvertently, the option to associate
user codes to relay 2 is automatically blocked.
different programming stages, in the following ways:
shown with LEDs 1:
· Light signal linked to beep.
· Disabled.
· Commanded by input I1.
Pulsing = confirmation of activation of services.
HNA/102
12÷16
260 max
120
14÷18
180 max
80
0 ÷ +35
key before the activation time
before the user code (to
. In order to avoid the