Acoustic Research wireless speakers AW877 Installatie- en bedieningshandleiding - Pagina 11
Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} Acoustic Research wireless speakers AW877. Acoustic Research wireless speakers AW877 13 pagina's. Wireless stereo speakers with auto-tuning
Ook voor Acoustic Research wireless speakers AW877: Installatie- en bedieningshandleiding (14 pagina's)
Pagina afdrukken
Troubleshooting
The following troubleshooting guide takes you through some of the more common
problems associated with the installation and/or operation of a wireless system. If the
problem persists, please call toll-free at 1-800- 732-6866 or visit www.araccessories.com.
Issue:
Cause and solution:
No sound
• Check that the transmitter AC power adapter is fully inserted into the wall outlet
• Confirm that the speakers are turned on and tuned to the transmitter—
• If you're using the power adapters, confirm that all three (for both speakers
• If you're using batteries, check that they are fresh and inserted with correct
• Check that the audio source component (stereo, TV, etc.) is turned on and
• Check that the speaker volumes are turned up.
• If you are using a Tape 2 Monitor output from your receiver/amp as the audio
Issue:
Cause and solution:
No sound/
• When using battery power, make sure the batteries are fresh and replace if
distortion/
static
• Check that the speaker STDBY./TUNED indicator is illuminated blue.
• Change the position of the channel select switch (1, 2 or 3) to change the
• Change the location of the transmitter. Place it as high and away from
• Move the transmitter and speaker closer together. Sending the signal through
and the power cord from the AC adapter is firmly connected to the transmitter
power input jack.
the STDBY./TUNED indicator light on the front of each speaker should be
illuminated blue.
and for the transmitter) are fully inserted into their wall outlets and the adapter
power cords are firmly connected to the power input jacks on the transmitter or
speaker.
or
polarity (+, –).
transmitting sound as it normally should.
output, check that you have pressed the Tape Monitor/Tape 2 button on the
front of the receiver. This will turn on the Tape 2 outputs, which may not have
been active.
necessary.
operating frequency. The speaker will detect the loss of signal and retune
automatically. You can also press the Power/Volume/Tuning control once to
make the speaker retune.
obstructions as possible. Avoid placing the transmitter directly on top of or
behind a TV.
certain materials, such as glass, tile, and metal, can decrease the effective
transmitting distance of the system.