Acoustic Research AW-D510 Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Acoustic Research AW-D510. Acoustic Research AW-D510 12 pagina's. 2.4ghz digital wireless hd headphones

Pagina afdrukken

Troubleshooting

The following troubleshooting guide takes you through some of the more common

problems associated with the installation and/or operation of a wireless system. If

the problem persists, please call toll-free 1-800-732-6866 or visit

www.araccessories.com.

Issue:

Cause and solution:

No sound

• Make sure the transmitter's AC power adapter is fully inserted into the wall

• Check that the audio source component (DVD player, TV, etc.) is turned on and

• Confirm that the headphones are turned on (the LED is blue) and tuned to the

• Make sure the headphones are charged—the LED on the right headphone should

• Check that the headphone volume is turned up.

• If you're using a variable output audio source (like a headphone jack or variable

• If you are using a Tape 2 Monitor output from your receiver/amp as the audio

Interrupted

• Move closer to the transmitter with the headphones on. Sending the signal

sound

• Try a different channel from the transmitter: press the ch select key on the

LED fails to

• Make sure the headphones are charged and that the transmitter is properly

light up

Headphones

• Move closer to the transmitter.

shut off

• The headphones' rechargeable battery needs to be recharged. Use the charging

automatically

Headphones

• If you're trying to find a different channel on the transmitter, the headphones

start beeping

• The headphones beep every few seconds when the batteries are running low. Use

outlet and the power cord from the AC adapter is firmly connected to the

transmitter power input jack.

transmitting sound as it normally should. If you're using a PC or DVD player,

make sure you've selected the correct audio output and that the sound is not

muted.

transmitter. If the LED is not blue, press the ch select key on the transmitter to

try a different channel. If this doesn't work, press and hold the mute/link key on

the headphone and the ch select/link key on the transmitter simultaneously for 3

seconds.

be blue.

output on a TV set), make sure the source component's volume is set high

enough for the transmitter to detect.

output, check that you have pressed the Tape Monitor/Tape 2 button on the

front of the receiver. This will turn on the Tape 2 outputs, which may not have

been active.

through certain materials, such as glass, tile, and metal, can decrease the effective

transmitting distance of the system.

transmitter's top panel.

connected to the audio source. Then, move the headphones close to the

transmitter and press the headphone power button again.

cable on the transmitter to recharge the headphones.

beep when they lock onto a new channel.

the charging cable on the transmitter to recharge the headphones.