3Doodler 2.0 Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} 3Doodler 2.0. 3Doodler 2.0 10 pagina's.
Ook voor 3Doodler 2.0: Snelstarthandleiding (2 pagina's), Handmatig (4 pagina's)

Pagina afdrukken

1. Troubleshooting and Cleaning the Pen

Step 5: Extrude/select your speed

Press and hold the button for the desired

extrusion speed (FAST (3) or SLOW (4) )

and wait for the heated material to

emerge from the pen tip. Releasing the

chosen speed button will cause the pen

to stop extruding the heated material.

If the pen stops and the RED LED

appears again, simply wait a moment for

the LED to change to the appropriate color again (the pen is simply

returning to its optimal heating temperature).

NOTE: After 5 minutes of inactivity the 3Doodler's heating

system will automatically power down. You will need to

press one of the buttons OR toggle the power switch off

and then on again to continue use.

If the plastic/filament is not extruding, it may be because the

existing plastic/filament (A) is too short or has fed beyond the

gearbox, and you will not be able to reverse it. Please use a new

strand of plastic/filament (B) or the Cleaning Tool to feed the

remaining plastic/filament through the pen. In order to feed the

Cleaning Tool past the gear system you will need to gently twist it

counter clockwise until you feel it move past the gears.

Note: For those of you who are curious, the distance between

the gearbox and the nozzle is under an inch.

Step 6: Double Click for Continuous Flow

Your 3Doodler can be set to

continuously extrude

plastic/filament without you

having to hold down on the

extrusion buttons. Simply

double-click on the desired

extrusion speed (FAST (3) or

SLOW (4) ) and your 3Doodler

will continuously extrude

plastic/filament for up to ten