Alto DYNAMATE Gebruikershandleiding - Pagina 16

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Alto DYNAMATE. Alto DYNAMATE 19 pagina's.

Further Information

Because of the nature of our digital sound processors and the variety of effects that can be achieved with them, there

are operational details, tips and advice too numerous to include in an instruction manual such as this. For additional

information, please visit our website at

can exchange ideas.

Troubleshooting

Power LED not lit: Is the Remote switch cable from the source unit (Cassette or CD Player) attached to the REM terminal

of the DYNAMATE, and is the source unit switched on? Are the

Is the Ground cable properly attached to the chassis of the vehicle or to an existing ground point that is known to be OK?

No Sound: Adjust the level of the Input Gain Controls. Adjust the level of the Output Gain Controls. Are the Input and

Output signal cables correctly connected? If there is only sound from one channel, swap the Left and Right channel Input

cables at the DYNAMATE - if the fault moves to the other channel then the fault is with the cable or source unit. If the

fault remains in the same channel, swap the Left and Right channel Output cables at the DYNAMATE - if the fault still

remains on the same

speaker

or the speaker). Check gain controls on those units and any input switching options. If the fault moves to the other speaker

then the DYNAMATE may be faulty - leave it installed in your system and return to your dealer so that they can check it.

Distorted Sound or Low Volume: Adjust the Input and Output Gain Controls of the DYNAMATE, and the Input Level

Controls of the power amplifier (and/or active crossover or additional processor where applicable). Check if the amplifier

has a built-in crossover network - is it switched correctly?

www.altomobile.com

then the fault is with a cable or a unit after the DYNAMATE (power amplifier, active crossover

, which includes a technical discussion forum where users

12V and GND (Ground) terminals connected correctly?

LTO