3DR ArduCopter Quad-C Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} 3DR ArduCopter Quad-C. 3DR ArduCopter Quad-C 19 pagina's.

2. Slide a piece of shrink tubing over the bullet connectors and apply heat to shrink.

heat can be applied with a soldering iron or a

should be fully covered by shrink tubing to avoid shorts.

3. Slide two pieces of shrink tubing on the red & black wires on the ESC.

4. Solder male Deans or your preferred connector to the red & black wires on the ESC.

Note: Make sure the black wire is soldered to the negative (-) terminal of the connector and

the red to the positive (+).

5. Pull the shrink tubing over the exposed connector leads and shrink it.

heat

gun.

Note: Female connectors