AkitikA VC102 Montagehandleiding - Pagina 6

Blader online of download pdf Montagehandleiding voor {categorie_naam} AkitikA VC102. AkitikA VC102 9 pagina's. Volume control kit

Install the Volume Control

Once you've attached the shielded cables to the volume control, remove the locating tab

(see Figure 3) from the volume control using needle nose pliers. Install the volume

control in the front panel as shown in Figure 4-Locating the volume control. Turn it on its

side, as shown, with the center lug a bit below the center-line of the mounting hole.

It's best if you have a nut driver to tighten the nut, although you can use pliers if you're

careful not to let them slip and scratch the front panel. Once the volume control is

installed and tightened, turn the shaft fully counterclockwise (viewed from the front

panel).

Loosen the set screw on the knob and slip it over the volume control shaft. Set the

indicator to 7 o'clock and tighten the set screw.

Page 6 of 9