ClearChoice Premium Series Gebruikershandleiding en installatiehandleiding - Pagina 5
Blader online of download pdf Gebruikershandleiding en installatiehandleiding voor {categorie_naam} ClearChoice Premium Series. ClearChoice Premium Series 7 pagina's. Under sink drinking water system
Pagina afdrukken5. To pierce the tubing, turn the valve handle clockwise (inward) until it becomes fully seated.
At this point the tube has been pierced and sealed and the valve is closed.
6. Keep the saddle valve closed for now, but turn on the water supply again. Turn on the main
kitchen sink faucet to flush any debris from the water line from the installation, and inspect
the saddle valve for leaks. Ensure any leak found is corrected before proceeding.
Installing on hard steel, iron, brass, or CPVC pipe:
1. Turn off the water supply and drain the line by opening a nearby faucet until the water stops
running.
2. Drill a 3/16" hole into the supply line (be careful not to drill through the opposite wall of the
pipe!). Use a hand-drill or battery-powered drill to reduce the risk of electric shock.
3. Turn the saddle valve handle until the lance appears no more than 3/16" beyond the rubber
gasket.
4. Place the lance over the hole in the supply line so that the lance fits into the hole. Insert the
back plate. Note that the back plate is reversible depending on whether you have 3/8" or
5/8" diameter tubing. Match the back plate so that it fits your pipe diameter as close as
possible.
5. While holding the saddle valve in place, tighten the brass screw to secure the valve firmly
against the pipe.
6. To pierce the tubing, turn the valve handle clockwise (inward) until it becomes fully seated.
At this point the tube has been pierced and sealed and the valve is closed.
7. Keep the saddle valve closed for now, but turn on the water supply again. Turn on the main
kitchen sink faucet to flush and debris from the water line from the installation, and inspect
the saddle valve for leaks. Ensure any leak found is corrected before proceeding.
Step 9 – Water Line Connections
1. Determine what length of water tubing is needed to extend from the saddle valve on the supply
line to the left side (inlet) of the water filtration unit assembly and cut a section of 1/4" tubing for
this purpose. Make sure that you cut the tubing straight across (not on an angle) and that all burrs
or rough edges are removed. Be sure to allow for some "slack" so there is some ability to move the
unit around under the sink in the future if necessary and to facilitate maintenance.
2. Slide the brass compression nut and white plastic ferrule over the water tubing. Then place the
plastic or brass insert into the tube.
3. Attach the tubing to the inlet of the saddle valve by tightening the brass compression nut.
Tighten with a wrench but do not over-tighten. Extreme force is not necessary.