3DUpFitters Ender 3 S1 Enclosure Kit Installatiehandleiding - Pagina 7

Blader online of download pdf Installatiehandleiding voor {categorie_naam} 3DUpFitters Ender 3 S1 Enclosure Kit. 3DUpFitters Ender 3 S1 Enclosure Kit 17 pagina's.

Pagina afdrukken

The front should look like the picture to the right. 

Locate the magnetic latches and use the wood screws to

attach them to the latch mount. Hand tighten and make sure

they're secure, but do not over tighten or they may strip. The

latch can be later adjusted front-to-back to make sure the door

is ﬂush with the door frame.

Each latch mount is attached via three screws. Use the

30mm cap head to secure the latch mount to the door

frame. You'll use 2 M4 12mm screws to attach the latch

mount to the right-side panel later in the assembly.

Attach the hinges to the door and door frame using M4

12mm screws and nuts. There will be some play in the

hole size so that you can adjust the door to swing freely.

acrylic at the location of each latch. Then, adjust the width of the metal strike plate so

that it is held on by the pressure of the two sides of the plate. The adhesive covering

will keep the metal strike plate from scratching the acrylic.

Attach the doorknob by ﬁrst inserting

the square M4 nut into the slot. Use a

16mm cap head screw to attach the

door.

Now that the latches are mounted it is time to connect the strike

plates. Each plate comes with a squishy adhesive covering the

same size as the plate. Carefully attach the adhesive side to the