esera automation ECO 10 Gebruikershandleiding - Pagina 9
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} esera automation ECO 10. esera automation ECO 10 13 pagina's. 1-wire controller
Pagina afdrukken
Art. No. 11601-24
14
Software
Data interface ESERA ASCII Text protocol
The Ethernet interface is configured with the aid of the Windows ESERA programme Config Tool 3, which
can be found in the download area of the ESERA online shop.
15
Configuration and Communikation with ECO 10
The ECO 10 has extensive configuration and formatting options that are read out and operated with the
ESERA Config Tool 3.
Since communication between ECO 10 and Config Tool 3 takes place via the open ESERA ASCII text
protocol, you can also exchange data with any terminal program (e.g.
via UDP / TCP/IP at any time with ECO 10 and carry out the configuration.
Details on the communication commands can be found in the document "Programming Manual", which can
be found in the download area of the ESERA online shop and within Config Tool 3.
Hinweis
For security reasons, only one socket data connection with the ECO 10 is possible at a time.
The IP address is preset to DHCP.
15.1
ESERA ASCII Text protocol
The ECO 10 provides a protocol in ASCII format. The ESERA text protocol in ASCII format can be used very
easily for configuration and analysis. Special emphasis was placed on good readability and traceability. The
ESERA text protocol works with "GET" and "SET" commands, which probably every programmer has already
used in his own projects.
* if the sensor or actuator supports Auto-E-Connect. For details, please refer to the operating instructions of the sensor or actuator.
All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA GmbH. Errors and technical modification subject to change. ESERA GmbH 2021
www.esera.de
11601-24 V1.0 R1.1 Manual
z.B. Hercules
oder Putty)
Page 9 of 13