3DUpFitters Prusa i3 MK3 Installatiehandleiding - Pagina 12

Blader online of download pdf Installatiehandleiding voor {categorie_naam} 3DUpFitters Prusa i3 MK3. 3DUpFitters Prusa i3 MK3 18 pagina's. Enclosure kit
Ook voor 3DUpFitters Prusa i3 MK3: Installatiehandleiding (11 pagina's)

Pagina afdrukken

6. Sealing Gaps

Once the enclosure is completely put together, it is time to make sure that each of the

panels is held tightly to each adjoining panel. The connectors are designed with a

small amount of play that allows you to make small adjustments for the perfect ﬁt.

1. Loosen screws on the panel to move.

2. Push that panel into place. You may need a friend to hold it tightly in the right spot.

3. Re-tighten the screws to hold the panel. Only tighten enough to hold the pieces

snuggly. DO NOT OVER-TIGHTEN! These parts are sturdy, but they're still all

made out of plastic.

Repeat the process, going around the enclosure looking to make sure all of the panels

are ﬂush to each other.

Once the gaps are sealed, you can then position

the enclosure. The biggest thing with the power

supply is to get the vent in the right place. If you

are using the silver power supply there isn't much

tolerance in the placement of the oﬀ/on switch

and power cable plug, so you'll have to get it

close. This will make it easier to turn oﬀ and on

and provide the best seal so that heat won't

escape.

Note: The image to the right is for the silver PSU.

If you have a black PSU refer to the section on

the Right Panel assembly.