3e Technologies International 3e-250 Gebruikershandleiding - Pagina 15

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} 3e Technologies International 3e-250. 3e Technologies International 3e-250 18 pagina's. Bluetooth to rs-232 cordless adaptor

Configuration Commands for the 3e-250 Bluetooth RS-232 Adapter
Command
Description
help
• lists all the supported commands
version
• displays the version of the software running on the device
config
• places the device in configuration mode. In this mode the Bluetooth
Radio function is inactive; no remote device can connect to it.
• the device will not be able to go into deep sleep in this mode
• syntax for this mode is "config <start|end>". The "start" argument
places the device in configuration mode and the "end" command
exits the configuration mode.
• arguments for this command are not optional. An error message is
echoed to the host when no arguments are supplied with the command.
devicename
• allows user to change default name (up to 50 characters).
• default device name is "3ETI Serial Device."
• command syntax is "devicename [new name for device]".
• arguments are optional. Using devicename without argument simply
displays current name.
• if new devicename is set, it will be echoed back to the host.
changebaud
• allows change to baud rate. (Default baud rate is 9600; maximum
baud rate is 115200).
• command syntax is "changebaud <baud rate>".
• arguments are not optional. Failure to supply argument causes an
error message to echo back to the host. An example of correct use
would be: "changebaud 115200". Baud rate will change to 115200
bits/sec.
• once baud rate is changed, the host application will have to change
its baud rate and reset the device to effect the baud rate change.
deviceaddress
• displays the 48bit Bluetooth device address for the device.
• no arguments are used with the command.
changepin
• allows user to change the default PIN "3eti" to set authentication and
encryption between two Bluetooth devices. Usage of this PIN is
optional and will be executed only if the remote device requests
authentication and encryption of all communications on the link.
• command syntax is "changepin <user pin>". The use of the argument is
not optional. PIN name can be from 4 to 16 alphanumeric characters.
User's Guide
9