DIW Funk touchShade DTRS-500 Instructies - Pagina 2
Blader online of download pdf Instructies voor {categorie_naam} DIW Funk touchShade DTRS-500. DIW Funk touchShade DTRS-500 2 pagina's.
Pagina afdrukkenInstructions for the touchShade switch DTRS-500
(RST602R)
Intended Use:
Roller blind switch DTRS-500:
The roller blind switch DTRS-500 is a switch for radio control of tubular
motors, awnings, blinds, etc. The functions are UP - STOP - DOWN
connection and assembly
Safety instructions for DTRS-500
In order to avoid electric shock, please only have it connected by a
specialist!
Make sure the neutral wire and live wire are properly connected.
- Strip the solid wires (solid conductors only) at least 7 mm and connect the
wires according to the diagrams below; ensure terminals are properly
tightened and no bare wire is visible.
- Suitable wire diameter for the terminal is 0.75mm²~ 2.5mm²
Danger! A terminal block cannot hold 2 pieces of
2.5mm² wire at the same time!
Teaching the DTRS-500
first use and connection/paring
The display of the UP and DOWN buttons
flashes simultaneously after switching on.
The device is then in learning mode.
Press the UP or DOWN button for about 4
seconds. After the button indicator
flashes, press and hold the ON button on
your transmitter until the indicator stops
flashing. The device is then trained and
ready for use.
Reset DTRS-500
After turning it on, press and hold the button on the control panel until the
indicator starts flashing. Then press and hold the OFF button on your
transmitter until the display stops flashing, then release the OFF button.
The device was thus reset.
Specification DTRS-500
Operating voltage: 230V/50Hz
Motor load: Max.500W
Frequency: 433.92MHz
Ambient temperature: 0-35°C
Size: 80x80x37.5mm
DTRS-500 Changing the direction of movement of the motor
Normally, pressing the UP button makes the motor go up, pressing the
STOP button stops the motor, and pressing the DOWN button makes the
motor go down. If you want to change the moving direction of the motor,
you just need to press the UP and DOWN button together more than three
seconds and the motor will run reversed.
Controlling the engine with the remote control
When the motor is off, press the ON button on the transmitter, the motor
rotating direction is ↑, press the OFF button on the transmitter, the motor
rotating direction is ↓ When the motor is in the ↑ state, first press the OFF
button to stop the motor, and then press the OFF button again to change
the motor rotating direction to ↓. When the motor is in ↓ state, first press the
ON key to stop the motor and then press the ON key again to change the
motor direction of the motor to ↑.
© DIW Dipl.-Ing. Weber Office Equipment Ltd. All rights reserved. Reproduction, even in part, is prohibited.
Reproductions of any kind require the written permission of the publisher.