ESI ESRTERFW Handleiding voor installatie-instructies - Pagina 9
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} ESI ESRTERFW. ESI ESRTERFW 16 pagina's. Wireless digital room thermostat
Ook voor ESI ESRTERFW: Gebruiksaanwijzing (8 pagina's)
Pagina afdrukken
- 1. Room Thermostat
- 1. Installation Instructions
- 2. Table of Contents
- 2. Technical Data
- 2. Installation Safety Instructions
- 2. Maintenance
- 2. Safety Notice
- 2. Fitting the Room Thermostat
- 2. Fitting the Receiver
- 2. Commissioning/Configuring
- 2. Wiring Diagram
- 2. DIP Switch Settings - Heating
- 2. Heating Mode
- 2. Receiver Manual Override
3. Insert the AA batteries provided and replace the front
cover of the thermostat.
Fitting the Receiver
Installation
1. Loosen the screws on the back-plate and remove from
the Unit.
2. Fix the back-plate, terminals at the top, either direct
onto a flat wall using wall plugs and screws or on a flush
mounting single conduit box. Route the wires through
the back of the wall plate and fit the wires to the wall-
plate in accordance with the relevant diagram and in
accordance with I.E.E. regulations.
3. Fit the Unit onto back-plate, and tighten the screws.
Ensure an appropriate fuse is fitted to the circuit before
reconnecting to the mains supply.
Commissioning/Configuring
1. If the receiver and thermostat have been supplied as
a kit, the units have already been paired in the factory
and no pairing is needed.
2. Power up the receiver and both lights should come on
for a few seconds.
3. Press and hold M/A (Manual/Auto) button
10) for approximately 10 seconds until the MANUAL
light
2
4. Insert batteries in the thermostat, turn dial up to 5 and
remove dial.
5. Press and hold the black button until the receiver light
goes off.
6. To check it is paired, turn the thermostat above room
(See page 10) begins to flash (green).
(See page
1
9