ESI FLEXRISE2 Gebruiksaanwijzing - Pagina 4

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} ESI FLEXRISE2. ESI FLEXRISE2 16 pagina's. 2 leg / 2 motor electric table base (36 inch to 72 inch)

Pagina afdrukken

SET UP SYNCHRONIZATION (KY0 and KY4)

1. Once you have fully assembled your desk. It needs to be synchronized at the

lowest position.

2. Ensure there are not obstructions for the desk to move vertically

3. Press and hold the "UP and DOWN" arrow buttons at the same time.

4. Continue to hold the "UP and DOWN" arrow buttons, the desk will lower until it

reaches the bottom (lowest point).

5. Release the buttons once the system beeps

1. If it does not beep, continue to hold the buttons for 3 seconds after the desk

reaches the lowest point.

6. The system has now been synchronized. KY0 version is now ready for use.

MEMORY SET POSITIONS (KY4 only)

1. To be performed after "Set up Synchronization"

2. Move the desk to the desired memory position

3. Press and hold the "UP" button and memory # button at the same time. (3 to 5

seconds)

4. Display will flash "P#" when programmed

5. For example, pressing "UP" and the number 1 for 3 to 5 seconds, the display with

flash "P1"

6. Repeat for programming positions 2, 3 and 4.

MOVING TO A MEMORY PRESET POSITION (KY4 HANDSET ONLY)

1. Ensure there are not obstructions for the desk to move vertically

2. Press and hold the memory button #

3. The desk will move to the preset position

NOTE: The memory preset button must be pressed and held with the desk is

moving to the preset position.

HANDSET PROGRAMMING

KY0

KY4